Note: today's batch is unusually weak — nearly every candidate is hashtag-spam Shorts with no description. This one is the least bad because it at least promises a specific, teachable skill.

Dialing in amperage is one of the first things a new stick welder has to get right, and it's also one of the most commonly botched. Too little current and your 7018 rod sticks to the plate, leaves a cold lump instead of a puddle, and produces slag that's a nightmare to chip. Too much and you burn through thin material, get excessive spatter, and undercut the toes of your bead.

As a "part 2" video, this presumably builds on a first installment that covered the basics — hopefully showing side-by-side beads at different amperages on the same rod diameter so you can see what "too cold," "just right," and "too hot" actually look like. The rule of thumb is roughly 1 amp per thousandth of rod diameter (so a 1/8" 7018 runs around 110-130A), but position, plate thickness, and machine type all shift that window.

At 239 subscribers, Siriwayo Joseph is exactly the kind of small-channel creator worth supporting if the content actually delivers on the title's promise of practical machine setup guidance.